55
The following table lists the various parameters displayed on the RECIP status screen.
PARAMETER DESCRIPTION
S1-S4, P1-P4, SY The active capacity control setpoint. S1-S4 indicate represent Suction
Pressure setpoints, P1-P4 represent Process Temperature setpoints, and SY
represents the Sequenced setpoint.
SP Suction Pressure
DP Discharge Pressure
OP Oil Pressure
IP Intermediate Pressure (two-stage machines only)
CP Capacity
ST Suction Temperature
DT Discharge Temperature
OT Oil Temperature
Status Banner
The STATUS BANNER is located at the bottom of the Compressor status screen, Active
Alarms & Failures screen, and Auto-Start Warning status screen. The Banner consists of
three highlighted sections which provide the user with the status of the following system
conditions.
Current System State
Current Operating mode
Alarm & Failure Status
To Next Page
Loading...
