3 Transducer Block Device Functions Proline Promass 83 FOUNDATION Fieldbus
128 Endress+Hauser
Sensor Data -
Density Coeff.
C0
read only This function shows the actual density coefficient C0.
! Note!
If the service code is used to call this parameter, this value can be edited.
" Caution!
A density adjustment can alter the calibration value of this coefficient.
Sensor Data -
Density Coeff.
C1
read only This function shows the actual density coefficient C1.
! Note!
If the service code is used to call this parameter, this value can be edited.
" Caution!
A density adjustment can alter the calibration value of this coefficient.
Sensor Data -
Density Coeff.
C2
read only This function shows the actual density coefficient C2.
! Note!
If the service code is used to call this parameter, this value can be edited.
" Caution!
A density adjustment can alter the calibration value of this coefficient.
Sensor Data -
Density Coeff.
C3
read only This function shows the actual density coefficient C3.
! Note!
If the service code is used to call this parameter, this value can be edited.
" Caution!
A density adjustment can alter the calibration value of this coefficient.
Sensor Data -
Density Coeff.
C4
read only This function shows the actual density coefficient C4.
! Note!
If the service code is used to call this parameter, this value can be edited.
" Caution!
A density adjustment can alter the calibration value of this coefficient.
Sensor Data -
Density Coeff.
C5
read only This function shows the actual density coefficient C5.
! Note!
If the service code is used to call this parameter, this value can be edited.
" Caution!
A density adjustment can alter the calibration value of this coefficient.
Sensor Data - Min.
Temp.Measured
read only The lowest fluid temperature measured appears on the display.
Sensor Data - Max.
Temp.Measured
read only The highest fluid temperature measured appears on the display.
"Flow" Transducer Block / base index 1400:
Parameter
Write access
with operating
mode
(MODE_BLK)
Description
To Next Page
Loading...
