ero electronic MKP - Default Parameters

149
Output typeOutput type
Output typeOutput type
Output type: Isolated output programmable as
- 0-20 mA
- 4-20 mA.
ScalingScaling
ScalingScaling
Scaling: programmable from -1999 to 9999.
Maximum loadMaximum load
Maximum loadMaximum load
Maximum load: 600 Ω.
AccuracyAccuracy
AccuracyAccuracy
Accuracy:
- 0.1 % when it is used as control output
- 0.05 % when it is used as analog retransmission.
NoteNote
NoteNote
Note: a too
little range scaling can deteriorate the output accuracy.
FilterFilter
FilterFilter
Filter: It is possible to apply a first order digital filter on the
retransmitted value.
The time constant of the filter may be programmed within 0 and
8 s.
Additional 5 + 5 outputs (OUT10 to 19)Additional 5 + 5 outputs (OUT10 to 19)
Additional 5 + 5 outputs (OUT10 to 19)Additional 5 + 5 outputs (OUT10 to 19)
Additional 5 + 5 outputs (OUT10 to 19)
FunctionFunction
FunctionFunction
Function: singularly programmable as Event output.
TypeType
TypeType
Type: Relay .
Relay typeRelay type
Relay typeRelay type
Relay type: SPST
Contact ratingContact rating
Contact ratingContact rating
Contact rating: 0.5 A @ 250 V on resistive load.
NoteNote
NoteNote
Note: The commons of the out 10 to 14 connected together
with the terminal 66 while the commons of the output 15 to 19
are connected with terminal 55.
ALARMSALARMS
ALARMSALARMS
ALARMS
Alarm actionAlarm action
Alarm actionAlarm action
Alarm action: direct or reverse function programmable.
Alarm functionsAlarm functions
Alarm functionsAlarm functions
Alarm functions: each alarm can be configured as process
alarm, band alarm, deviation alarm, alarm on main or
secondary control output value.
Alarm resetAlarm reset
Alarm resetAlarm reset
Alarm reset: automatic or manual reset programmable on each
alarm.
Alarm maskingAlarm masking
Alarm maskingAlarm masking
Alarm masking: each alarm can be configured as masked
alarm or standard alarm.
This function allows to delete false indication at instrument start
up and after a set point change.
Process alarmProcess alarm
Process alarmProcess alarm
Process alarm:
Operative modeOperative mode
Operative modeOperative mode
Operative mode: Minimum or maximum programmable.
ThresholdThreshold
ThresholdThreshold
Threshold: programmable in engineering unit within the input
range.
HysteresisHysteresis
HysteresisHysteresis
Hysteresis: programmable in engineering units from 1 to 200
digits.
Band alarmBand alarm
Band alarmBand alarm
Band alarm
Operative modeOperative mode
Operative modeOperative mode
Operative mode: Inside or outside programmable.
ThresholdThreshold
ThresholdThreshold
Threshold: two thresholds programmable:
- Low - from 0 to -1000 digits.
- High - from 0 to +1000 digits.
HysteresisHysteresis
HysteresisHysteresis
Hysteresis: programmable in engineering units from 1 to 200
digits.
XKP-1-D1.pmd 25/05/2006, 11.28149