ero electronic MKP - Alarm 1 Hysteresis; Alarm 2 Hysteresis; Alarm 3 Hysteresis; Alarm 4 Hysteresis

77
Gr. 3Gr. 3 Gr. 3Gr. 3
Gr. 3
- Alarm 1 hysteresis - [r.C16]- Alarm 1 hysteresis - [r.C16]
- Alarm 1 hysteresis - [r.C16]- Alarm 1 hysteresis - [r.C16]
- Alarm 1 hysteresis - [r.C16]
This parameter is available only when Out 1 is configured as
alarm output (“O1.Fn” [C.E01] = “ALr.1”)
Range: from 1 to 200 digits
- Alarm 2 hysteresis - [r.C17]- Alarm 2 hysteresis - [r.C17]
- Alarm 2 hysteresis - [r.C17]- Alarm 2 hysteresis - [r.C17]
- Alarm 2 hysteresis - [r.C17]
This parameter is available only when Out 2 is configured as
alarm output (“O2.Fn” [C.E02] = “ALr.2”)
Range: from 1 to 200 digits
- Alarm 3 hysteresis - [r.C18]- Alarm 3 hysteresis - [r.C18]
- Alarm 3 hysteresis - [r.C18]- Alarm 3 hysteresis - [r.C18]
- Alarm 3 hysteresis - [r.C18]
This parameter is available only when Out 3 is configured as
alarm output (“O3.Fn” [C.E03] = “ALr.3”)
Upper display: Gr.3
Lower display: HSA3
Range: from 1 to 200 digits
- Alarm 4 hysteresis - [r.C19]- Alarm 4 hysteresis - [r.C19]
- Alarm 4 hysteresis - [r.C19]- Alarm 4 hysteresis - [r.C19]
- Alarm 4 hysteresis - [r.C19]
This parameter is available only when Out 4 is configured as
alarm output (“O4.Fn” [C.E04] = “ALr.4”)
Range: from 1 to 200 digits
- Group 3 default data loading - [r.C20]- Group 3 default data loading - [r.C20]
- Group 3 default data loading - [r.C20]- Group 3 default data loading - [r.C20]
- Group 3 default data loading - [r.C20]
Range: OFF = No loading data
ON = Loading data
XKP-1-D1.pmd 25/05/2006, 11.2877