EasyManua.ls Logo

ero electronic MKP - Time out for the Soft Start; External Control for AUTO;MANUAL Mode; External Control for Reverse;Direct Output Action Selection; Group 5 Default Data Loading

Default Icon
172 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
86
Gr. 6Gr. 6
Gr. 6Gr. 6
Gr. 6
- Time out for the soft start - [r.E16]- Time out for the soft start - [r.E16]
- Time out for the soft start - [r.E16]- Time out for the soft start - [r.E16]
- Time out for the soft start - [r.E16]
This parameter is available when at least one output is
configured as control output and no logic input is configured as
“Output limiter activator”.
Range: from 1 to 540 min.
Above this value the display shows “InF” and the limiting action
is always active.
NOTENOTE
NOTENOTE
NOTE: The tOL can be always modified but the new value will be
used only at the next device power up
- External control for AUTO /MANUAL mode- External control for AUTO /MANUAL mode
- External control for AUTO /MANUAL mode- External control for AUTO /MANUAL mode
- External control for AUTO /MANUAL mode
- [r.E17]- [r.E17]
- [r.E17]- [r.E17]
- [r.E17]
This parameter is available when one of the logic inputs is
configured for Auto/Manual selection and no program is
running.
Range:On the Auto/Manual selection is made by logic input
only
OFF the Auto/Manual selection is made by “Man” key
or serial link only.
- External control for reverse/direct output- External control for reverse/direct output
- External control for reverse/direct output- External control for reverse/direct output
- External control for reverse/direct output
action selection - [r.E18]action selection - [r.E18]
action selection - [r.E18]action selection - [r.E18]
action selection - [r.E18]
This parameter is available when one of the logic inputs is
configured for direct/reverse output action selection.
Range:On the reverse/direct selection is made by external
contact only
OFF the reverse/direct selection is made by “Cn.Ac”
[r.d08] parameter or serial link only.
- Group 5 default data loading - [r.E19]- Group 5 default data loading - [r.E19]
- Group 5 default data loading - [r.E19]- Group 5 default data loading - [r.E19]
- Group 5 default data loading - [r.E19]
Range: OFF = No loading data
ON = Loading data
Gr. 5Gr. 5
Gr. 5Gr. 5
Gr. 5
XKP-1-D1.pmd 25/05/2006, 11.2886

Table of Contents

Related product manuals