ero electronic MKP - Events; Deviation Alarm; Alarm on the Main Output Value; Alarm on the Secondary Output Value

150
Deviation alarmDeviation alarm
Deviation alarmDeviation alarm
Deviation alarm
Operative modeOperative mode
Operative modeOperative mode
Operative mode: High or low programmable.
ThresholdThreshold
ThresholdThreshold
Threshold: programmable from - 1000 to +1000 digits.
HysteresisHysteresis
HysteresisHysteresis
Hysteresis: programmable in engineering units from 1 to 200
digits.
Alarm on the main output valueAlarm on the main output value
Alarm on the main output valueAlarm on the main output value
Alarm on the main output value
It is possible to obtain an alarm condition when the main control
output is lower or higher than a programmed value.
Operative modeOperative mode
Operative modeOperative mode
Operative mode: Minimum or maximum programmable.
ThresholdThreshold
ThresholdThreshold
Threshold: programmable from 0.1 to 100.0 % of the output.
HysteresisHysteresis
HysteresisHysteresis
Hysteresis: programmable from 0.1 to 20.0 %.
Alarm on the secondary output valueAlarm on the secondary output value
Alarm on the secondary output valueAlarm on the secondary output value
Alarm on the secondary output value
It is possible to obtain an alarm condition when the secondary
control output is lower or higher than a programmed value.
Operative modeOperative mode
Operative modeOperative mode
Operative mode: Minimum or maximum programmable.
ThresholdThreshold
ThresholdThreshold
Threshold: programmable from 0.1 to 100.0 % of the output.
HysteresisHysteresis
HysteresisHysteresis
Hysteresis: programmable from 0.1 to 20.0 %.
EVENTSEVENTS
EVENTSEVENTS
EVENTS
All the 14 digital outputs are programmable as events.
In this case they are used as:
- Break events
- Timer events
- Output Power OFF annunciator
- End of cycle indicator
- End of profile indicator
- RUN indicator
- WAIT indicator
- Error condition on the main input (overrange, underrange, open
or short circuit).
- Error condition on the auxiliary input.
- Error condition on both inputs.
- Auto/Man mode annunciator
- Hold annunciator
XKP-1-D1.pmd 25/05/2006, 11.28150