ero electronic MKP - Group 2 Default Data Loading; Run Time Group 3; Manual Reset of the Alarms; Alarm 1 Threshold

73
Gr. 3Gr. 3 Gr. 3Gr. 3
Gr. 3
tHU = Thursday
Fri = Friday
Sat = Saturday
SUn = Sunday
NOTENOTE
NOTENOTE
NOTE: this is a readable parameter only and it cannot be
modified.
- Group 2 default data loading - [r.b09]- Group 2 default data loading - [r.b09]
- Group 2 default data loading - [r.b09]- Group 2 default data loading - [r.b09]
- Group 2 default data loading - [r.b09]
Range: OFF = No loading data
ON = loading data
Run time group 3 [r.Cxx]Run time group 3 [r.Cxx]
Run time group 3 [r.Cxx]Run time group 3 [r.Cxx]
Run time group 3 [r.Cxx]
ALARM THRESHOLD AND HYSTERESIS VALUE
- Manual reset of the alarms - [r.C01]- Manual reset of the alarms - [r.C01]
- Manual reset of the alarms - [r.C01]- Manual reset of the alarms - [r.C01]
- Manual reset of the alarms - [r.C01]
Range: ON/OFF
Change to ON and then depress “FUNC” key to reset/
acknowledge the alarm condition.
NOTESNOTES
NOTESNOTES
NOTES:
1) The reset/acknowledge function is always enabled.
2) When one of the logic input is configured as alarm reset,
both actions (from keyboard and from logic input) are active.
- Alarm 1 threshold - [r.C02]- Alarm 1 threshold - [r.C02]
- Alarm 1 threshold - [r.C02]- Alarm 1 threshold - [r.C02]
- Alarm 1 threshold - [r.C02]
This parameter is available when alarm 1 is configured as
process, deviation, main control output or secondary control
output alarm (“A1.tP” [rF.01] = “Proc” or “dEV” or “ñAin” or
“SECn”)
XKP-1-D1.pmd 25/05/2006, 11.2873