ero electronic MKP - Main Control Output in Engineering Unit; Main Output Decimal Point Position; Main Output Full Scale Readout; Main Output Initial Scale Readout

45
CnF. 3CnF. 3 CnF. 3CnF. 3
CnF. 3
- Main output initial scale readout - [C.F09]- Main output initial scale readout - [C.F09]
- Main output initial scale readout - [C.F09]- Main output initial scale readout - [C.F09]
- Main output initial scale readout - [C.F09]
This parameter will be available only when "ñ.SCL" ("Main
control output in engineering units" [C.F07]) is set to "YES".
Range: from -199 to 999
NOTENOTE
NOTENOTE
NOTE: The Main output initial scale value can be higher than
the Main output full scale value.
- Main output full scale readout - [C.F10]- Main output full scale readout - [C.F10]
- Main output full scale readout - [C.F10]- Main output full scale readout - [C.F10]
- Main output full scale readout - [C.F10]
This parameter will be available only when "ñ.SCL" ("Main
control output in engineering units" [C.F07]) is set to "YES".
Range: from -199 to 999
- Main control output in engineering unit- Main control output in engineering unit
- Main control output in engineering unit- Main control output in engineering unit
- Main control output in engineering unit
- [C.F07]- [C.F07]
- [C.F07]- [C.F07]
- [C.F07]
This parameter will be available only when main control output
is configured.
Range:nO = Scalable is not required
YES = Scalable is required
NOTENOTE
NOTENOTE
NOTE: This scaling allows you to display the output value in
engineering units instead of in percent.
- Main output decimal point position - [C.F08]- Main output decimal point position - [C.F08]
- Main output decimal point position - [C.F08]- Main output decimal point position - [C.F08]
- Main output decimal point position - [C.F08]
This parameter will be available only when "ñ.SCL" ("Main
control output in engineering units" [C.F07]) is set to "YES".
Range:
----. = No decimal figure
---.- = One decimal figure.
--.-- = Two decimal figures.
XKP-1-D1.pmd 25/05/2006, 11.2845