A. 7
- turned OFF the bargraph displays (MKC only);
- sets analog retransmissions to the retransmitted initial
scale value;
- sets alarms in no alarm condition;
- sets events to OFF;
- disables the serial link;
- the time out will be removed.
2) When the modify mode is disabled by V101 (SW3), the V or
W push-button pressure has no effect.
Push MENU pushbutton again and select the:
Default configuration and user parameter setting groupDefault configuration and user parameter setting group
Default configuration and user parameter setting groupDefault configuration and user parameter setting group
Default configuration and user parameter setting group
[C.Cxx][C.Cxx]
[C.Cxx][C.Cxx]
[C.Cxx]
Upper display: ConF
Ranges:tb.1 =load the default configuration parameters of
the table 1 (European)
tb.2 =load the default configuration parameters of
the table 2 (American)
LOAd=load the user setting (all run time and
configuration parameters)
SAVE=save the current setting of the run time and
configuration parameters (as user default
setting)
Lower display: dFlt when "Tb.1" or "Tb.2" is selected
USEr when "LOAd" or "SAVE" is selected
Push MENU pushbutton again.
The central display will show:
and then the display will show:
The default parameter loading procedure is ended.
The following is a list of the default configuration parameters of
tb 1 and tb 2:
TABLE 1TABLE 1
TABLE 1TABLE 1
TABLE 1
Configuration group 1 [C.dxx]Configuration group 1 [C.dxx]
Configuration group 1 [C.dxx]Configuration group 1 [C.dxx]
Configuration group 1 [C.dxx]
PARAM. VALUE NOTES
Ln.Fr 50 Hz
ñ.In.t 3 TC K with °C
ñ.In.d
----. (No decimal figure)
ñ.In.S dIS Disabled
ñ.In.L - 100 °C
ñ.In.H 1370 °C
OFSt 0 °C
dS.FL 0 (No filter)
xkp-a-D1.pmd 25/05/2006, 11.297
To Next Page
Loading...
