Euphonix Max Air Mixing Console Operation Manual Center Section
138
Figure 7-15 CM404 Oscillator
• On: Toggles the oscillator on/off.
• Setup: Displays the Oscillator Setup popup.
Figure 7-16 Oscillator Setup Popup
Set the Oscillator destination by touching the Group Busses, Main Busses, Aux Bus-
ses, or All Busses keys (4).
Turn the oscillator on by activating the Osc On button (1). Select the oscillator type by
touching the Sine Wave, White Noise, or Pink Noise keys (2). These keys intercancel
so only one type can be selected at a time.
Select the oscillator frequency by touching the 100 Hz, 1 kHz, or 10 kHz keys to the
right of the faders (3). In addition, there is a Variable frequency button above the
10 kHz button. Activate this button and use the Frequency fader to set the frequency
(20 Hz to 21 kHz). All of the frequency keys intercancel.
Set the oscillator level by moving the Level fader (111 dB of gain).
SetupSetup
OnOn
OscillatorOscillator
1
2
3
4
To Next Page
Loading...
