Euphonix Max Air User Manual

Euphonix Max Air Mixing Console Operation Manual Quickstart to Common Tasks
36
3.4.2 Route to the Main Sections and Busses
Route Channels
1. Press All key on center section just below the left of the screen.
2. Press the Main button at the top of any strip to select Main section routing on
all strips.
The WX keys at the bottom of the knobsets allow paging if there are more than
four Main sections.In this case the Prog (Main section E) appears on the 2
nd
page.
3. The four Main sections are shown as SubA, SubB, SubC and SubD in each
Strip. To route the channel to SubA, press the On key next to the knob labeled
SubA.
The routing LED at the top of the Strip shows the channel is routed to Main
section A. Do this for the first 16 Strips.
4. Press any Strip’s Swap button and repeat steps 2 and 3 so that the backup mics
plugged into channels 17–32 are also routed to Main section A.
Route Subgroups A–D, to the E Main Section (Program Output)
1. Press the blue Wave key next to the first center section fader which controls
MF Master SubA.
This brings the MF Master’s parameters into the Super Channel to the right of
the Touchscreen.
2. Select Super Channel from the Main Menu buttons to display this same MF
Master’s parameters on the screen.
3. Route this MF Master, which controls SubA, to the program Main section E by
pressing the Setup button in the top left routing box on the screen.
4. Select the Main sections tab Section A–H and then select the Prog Main sec-
tion (fifth from top: Main section E).
5. Repeat for the remaining three the Main sections B–D.

Euphonix Max Air Specifications

General

Brand	Euphonix
Model	Max Air
Category	Music Mixer
Language	English