Euphonix Max Air Mixing Console Operation Manual Quickstart to Common Tasks
38
3.5 Meters
After channels are assigned to the surface, set the meters to suit your needs.
3.5.1 Setting the Fader Meters On Each Strip
We recommend beginning here since you will be able to see signal when you patch into
the channel.
1. Select Meters from the Main Menu.
2. Select the Fader tab.
This view shows all available Strips on your Max Air Console.
3. Touch Select All, then choose Fader in the Meter Display area to the right to
enable the meter next to each fader on the Strips.
When you begin patching audio into console, you will now see signal on each
channel as you patch.
3.5.2 Screen Meters on the Touchscreen
There are eight meter banks across the top and down the right side of the Touchscreen.
You can choose from a wide variety of signals to display here. Since there are meters
set up on every channel, it is probably best to select the screen meter area to display
Subgroups, Aux Masters, Solo, and Program. In this example we will place the meters
for these busses on the screen.
1. Select Meters from the Main Menu.
2. Select the Screen tab.
3. Select the left-most meter bank area (selected bank shows a yellow outline
box).
4. To select the four stereo subgroup masters we created earlier, press the Main
Sections button in the Function area.
5. Select Main section A (labeled SubA in the Main Section box).
You will see the SubA stereo meters appear in the selected bank.
6. Select the adjacent meter bank to the right and repeat above steps until SubA,
SubB, SubC, and SubD meters are visible.
On the fifth meter bank from the left, place eight Aux masters:
7. Select the fifth meter bank area from the left.
8. Select Aux Busses from the Function area – the available aux busses buttons
appear on the right area of the screen.
To Next Page
Loading...
Need help?
General
