Euphonix Max Air Mixing Console Operation Manual Quickstart to Common Tasks
39
9. Touch the Select Range button in the Aux Busses view. Touch 1, then 8.
This places the first eight aux meters in the fifth bank.
10. Repeat above steps for the Solo (in Solo Bus), Program (in Main sections by
selecting Main section E), and Control Room Meters (in Control Room).
The names that appear below the meters are the names assigned to the busses earlier.
Metering Multiple MF Masters in One Block
The previous example used four meter blocks to show four Main sections A–D. Be-
cause these four Main sections are assigned to four MF Masters (33–36) and to the cen-
ter faders, it is possible to place all four of these stereo meters in one bank.
1. Select the bank for the meters.
2. Select the Strips function then select the Center tab.
3. Select a meter bank and touch the first four buttons to bring the four MF Mas-
ters into one block.
Channel/Strip Metering
You can put channel meters along the top of the Touchscreen. There are 48 meter spac-
es available along the top row, not including the right corner section. Note that there are
two options with the Channels and Strips buttons: channels are the actual logical chan-
nels, Strips are the physical position of the Strips on the console. If you set the meters
to show channels, these will not necessarily match what is on the actual console Strips.
When you select the Strips button you will notice that you can set the meters to look at
just the Main or the Swap or whatever is on the Fader by selecting the appropriate tab
below the bank of buttons. If you select Fader, the meters change when you press the
Swap button on a Strip. The meters will read the signal path that is being controlled by
the actual fader. Also note that the position of the meter point in a channel can be indi-
vidually set to one of seven positions, so it can meter pre- or post-fader, pre- or post-
EQ, etc. The position of the meter in the channel signal path can be set by selecting the
Super Channel Main Menu button, then the Setup button in the Process Order box to
the left.
To Next Page
Loading...
Need help?
General
