Euphonix Max Air Mixing Console Operation Manual Quickstart to Common Tasks
30
3.2.3 Label Destination Ports and Signals
Select the Destinations tab to name the output MADI ports and their individual signals.
Their names will depend on how these MADI ports are connected to the outside world.
In the system diagram (Figure 1-1), four ports are shown. One of these ports is always
used for the monitor outputs that connect to the MC524 Monitor Interface so only three
ports appear in the destinations list as Hub1-1, Hub1-2, Hub1-3. In the above example,
Hub1-1 is connected to 24 analog outputs, the other two to 56-channel digital format
converters. Rename the Hub1-1, Hub1-2, Hub1-3 ports and their individual signals.
3.2.4 Label Individual Signals
From the Patch view:
1. Select the Sources tab.
2. Select Mic Line 1 from the list on the left.
3. Select Rename Port and enter Mic 1-24 using the keyboard popup.
This enters meaningful names into each of the 24 mic input name slots.
4. Each mic can now be individually named. Touch the first beige box in the
Name column that shows Mic 1-24-1. Use the keyboard popup to rename it
Mic 1. You can use the hardware keyboard’s down arrow to tab to the next
name field.
5. Touch the gray Analog 1-24 button (the second gray button from the top-left,
originally labeled Hub 1-2).
6. The names in the beige Name list can now be changed to reflect the actual
sources connected to these 24 analog inputs (VTRA1, VTRA2, TEL1, etc.).
7. Touch the gray Digital In 1 gray button (the third from top-left) to rename the
individual digital inputs from the third MADI port. Do the same for the fourth
Hub input we earlier named Digital In 2.
To Next Page
Loading...
Need help?
General
