Euphonix Max Air Mixing Console Operation Manual Quickstart to Common Tasks
37
Alternate Method of Routing to Main Sections – Busses/Main View Screen
1. Select the Busses Main Menu button.
2. Select the Main View tab.
3. Touch the Strip View button and select Main from the arrow keys at the top.
4. Select Main section B from the row of buttons along the bottom.
5. Touch the top knob bank to highlight 16 channels.
The knob bank highlighted corresponds to center section’s 16 Soft Knobs.
6. Touch the On key using the buttons just below the screen for the applicable
channels to send to sub B.
7. The arrow keys at the top allow routing for Main Strips, Swap Strips and the
Center Section’s eight faders (which have the MF Master Subgroups A, B, C
and D assigned to them).
3.4.3 Using the 24 Group Busses
Max Air includes 24 Group busses. These are very useful for additional clean feeds or
extra stereo outputs. As an example we could use Groups 1 and 2 as a stereo foldback
output.
1. Select Busses from the Main Menu and the Group tab.
2. Check that 1 and 2 are set to stereo. If not select the stereo format from the For-
mat Selector, select busses 1 and 2, and press the Set Format button.
For mono mix minus, these could be set as mono busses.
3. To route a channel to these busses, press the Group button at the top of a Strip.
The group pairs show next to the four knobsets.
4. Press the two buttons below the 1/2 group display next to the top to route the
channel to these busses.
The routing LEDS at the top of the channel light to show routing to Groups 1
and 2.
5. The output level of the groups can be brought up on the Soft Knobs below the
screen by pressing the Group Bus Masters button on the surface just below
the right edge of the Touchscreen.
To Next Page
Loading...
