Euphonix Max Air Mixing Console Operation Manual Center Section
147
7.9 Global Functions
Figure 7-25 Global Function Keys
All Key
Press the All key so it is lit. Now pressing any channel strip’s Swap key, Knobset Select
key (*, Ins/Inp, Dyn, EQ, Filt, Pan, Aux, Main, Group), or W X keys causes all strips
to perform that function.
For example, when All is on, hitting Swap on any single channel strip causes all strips
to swap. Hitting an EQ key assigns the EQ knobset to all strips.
Note that All only works with knobset selection. It does not apply to a bank of 8 strips
if In/Out key is pressed on those strips. It also does not work on a bank of 8 strips if
Expand is on those strips.
All stays lit and active until pressed again, at which point it toggles off.
Clear
Clear works with the function on the Super Channel or any channel strip to clear a func-
tion. Clear lights when active. Pressing a Select key of any type on either a channel
strip or the super section clears the parameter or function. The Clear key turns off after
each use; it is a one-shot key.
Copy, Link, and Workstation
Reserved for future use.
Workstation
Setup
All
Clear
Copy
Link