A1000 20 532210 04 - Rev.A
6
3
5
2
Nm
11
Translation of the original instructions
ENGLISH
6.1 ASSEMBLING THE COMPONENTS
!
Keep to the positions indicated in the relevant diagram:
105/106/107.
MECHANICAL STOPS
!
SINGLE LEAF: 2 mechanical stops are required. Place them at the two
ends of the profile to begin with.
DOUBLE LEAF: 4 mechanical stops are required. Place 2 of them at the
two ends of the profile and 2 in the middle to begin with.
1. Insert the mechanical stops from the side or front 6-
.
2. Make sure that they are resting in the correct position on the pro-
file - 6-
and temporarily fasten each mechanical stop 6-
.
After assembling the leaves, the stops’ positions must be adjusted.
To Next Page
Loading...
