FAAC A1000 - 11. Assemble the Belt, Casing and Accessories

A1000 35 532210 04 - Rev.A
38






Left leaf
Right leaf
Left leaf
Right leaf
Translation of the original instructions
ENGLISH
Translation of the original instructions
ENGLISH
Double leaf with rM = 1
(Default)
11.1 MOUNTING THE BELT
Close the leaves at the centre line (closing point in case of single leaf).
Move the leaves by hand and ensure the movement is smooth and
friction-less along the stroke.
!
It is mandatory to use a FAAC belt for the A1000
1. Place one end of the belt over the pulley of the motor. Fasten the
two ends using the fittings 38(1) and screws 38(2).
2. Position the assembled fitting with the belt on the carriage. Keep
to the positions indicated in 38 and fasten using the screws
38-

.

In case of double leaf, the belt joint must be fastened on the lower fitting
(on the left leaf).
The position of the belt fitting determines the opening direction.
3. Position the belt also on the pulley of the second motor.
11. ASSEMBLE THE BELT, CASING AND ACCESSORIES
RISKS
PERSONAL PROTECTIVE EQUIPMENT
REQUIRED TOOLS
8
6
Do not place hands between: the pulley and belt or between the sliding
guide and carriage wheels.
Double leaf with rM = -1
Passage opening
Passage opening