FAAC A1000 - AUX Errors and Troubleshooting

A1000 69 532210 04 - Rev.A
Translation of the original instructions
ENGLISH
17 AUX Errors
AUX Errors Intervention required
200
200
UC Failure (Corrupted FW or Corrupted RAM) Carry out board reset; if the error persists replace the board.
201
201
Faulty AUX Motor Check motor wiring. Reset board; if the error persists, replace the AUX motor.
202
202
High mechanical friction Manually check smooth sliding of the leaves along the entire space acquired during setup
203
203
AUX Motor Driver Carry out board reset; if the error persists replace the board
204
204
Firmware (FW) not compatible Update board Firmware
205
205
Motor Rotation Check AUX Motor wiring
206
206
Encoder Fault Check encoder wiring
216
216
Communication problems between the 2 boards Carry out board reset; if the error persists replace the board
217
217
Incorrect Opening Position Carry out board reset; if the error persists replace the board
218
218
Obstacle Check for any obstacles
219
219
Incorrect ID Replace the board
220
220
VMain Carry out board reset; if the error persists replace the board
221
221
Timeout Carry out board reset; if the error persists replace the board
222
222
Test VMain Replace the board