FAAC A1000 - 11.7 Installing the XB LOCK Motor Block; 11.8 Adjusting the XB LOCK Motor Block

A1000 42 532210 04 - Rev.A
51
52

2
53
3
6
4
Nm
3
5
12
Nm
3
3
3
Translation of the original instructions
ENGLISH
11.7 INSTALLING THE XB LOCK MOTOR BLOCK
1. Install the motor block by resting it on the motor body and secur-
ing it using the two M5 screws 51-

.
2. Close the leaves.
3. Manually push the lever 52-

towards the motor shaft. Check
correct coupling.
4. Move the motor block lever to check the clearance between the
motor shaft and the motor block coupling 52-

. If it is incor-
rect, adjust it as described below. 53-

.
5. Fasten the motor block using the two M5 screws 51-

.
11.8 ADJUSTING THE XB LOCK MOTOR BLOCK
1. Loosen the two screws 53-

that connect the belt fitting to the
carriage (on both carriages in the case of a double leaf).
2. Slightly move the belt fitting horizontally until there is
a clearance
a clearance
between the coupling of the motor shaft and the motor block by
between the coupling of the motor shaft and the motor block by
moving the motor block lever
moving the motor block lever
51
51
-
-


.
.
3.
3.
re-tighten the screws that were previously loosened.
re-tighten the screws that were previously loosened.