314
www.factoryfive.com 508-291-3443
Push the small button studs through the holes on the sides of the glass.
Push the medium 0.922” rubber washers onto the small button studs on the inside of the glass.
Put a washer on the small button stud.
Carefully thread on and tighten a jam nut on the bottom of the small button stud.
Thread on and tighten a ball stud on the small button stud.
Repeat for the other side.
Attach the trunk latch to the rear window using the included gasket on the inside of the glass and the ⅝”
long Philips head screws provided. Make sure there is a rubber gasket on each side of the glass.
To Next Page
Loading...
