Fagor QC-PDS - Page 106

 Drives
138
3.
DRIVES
Single-drives
· 106 ·
Ref.2003
· 106 ·
QC-PDS
HARDWARE
B10B|B10A connectors.
Industrial 100 Mbps Ethernet. Digital SERCOS-III interface
RJ-45 connectors establish communications through a SERCOS-III digital
interface through a 100 Mbps industrial Ethernet network, with a structure
that serves an inline topology between the QC-DR-  - F  drives and the
QUERCUS CNC numerical control governing the axes. All of which are
connected to the network.
The physical connection of the Ethernet BUS between drives
· either single
or dual · and the power supply, if it is regenerative, is made using the
following cable:
The physical connection of the Ethernet bus between the QUERCUS CNC
numerical control and one of the single or dual drives or a regenerative
power source is made using a cable:
Installation
See section, 2.2 CONNECTION TREE in the QUERCUS CNC installation
manual · man_qc_60_65_inst.pdf ·
for more information on the
identification of the modules connected to the SERCOS-III bus .
See section, INTERCONNECTION on 8.6.3 SERCOS-III CONNECTIONS.
NOTE. Only available for QC-DR-
 -F  models.
F. H3/39
B10B|B10A connectors. Digital SERCOS-III interface.
SERCOS-III cable Length
QC-FBC-0.25
0.25 m
NOTE. This cable is available upon request. One cable per drive.
SERCOS-III cable Length
QC-SBC-   7 m
QC-SBC-FLEX-  > 7 m
NOTE. This cable is only available upon request.