6.
See figures.
CHOKE RPS-160. Unpacking the unit.
1. OPEN COVER
2. LIFT THE SIDEWALLS OF THE BOX
3. LOOSEN THE 4 LAG SCREWS FROM THE BOTTOM VERTICES ATTACHING
THE EQUIPMENT TO THE BOARD
4. RAISE THE EQUIPMENT TO A MINIMUM HEIGHT WITH A HOIST, BY
HITCHING THE SLINGS WITH A HOOK THROUGH THE FOUR EYEBOLTS OF
THE UPPER VERTICES
5. REST THE EQUIPMENT ONTO A STABLE AND SAFE PLACE
MAKE SURE NO OTHER PERSON IS IN THE
AREA BEFORE PERFORMING THIS TASK
6. INSIDE THE CABINET, FASTEN THE EQUIPMENT TO THE FLOOR USING
THE HOLES DESIGNED FOR THIS PURPOSE. SEE DIMENSIONS IN THE
USER MANUAL. LEAVE A 100 mm CLEARANCE AT THE BACK OF THE
CABINET
PLACE FLAPS
(TABS) VERTICALLY
PLACE FLAPS
(TABS) VERTICALLY
To Next Page
Loading...