Installation
INSTALLATION
Connection of the control and communications signals
8.
Ref.2003
· 291 ·
QC-PDS
HARDWARE
Handling fiber optic cables
FAGOR supplies the fiber optic cables with its terminals protected with a
hood. Remove the terminal protecting hood before connecting any of these
cables.
Either to remove the terminal protecting hood or to connect and disconnect
the cable, the cable must always be held by the terminal, never pull at the
cable because it could get damaged. See figure F. H8/40.
Transmission speed selection
Both the QC-RPS-160-SN0 main regenerative power supply and the QC-
DR-275-SS2 drive have a SERCOS-II board that can transfer data at
speeds of 2, 4, 8 or 16 MBd.
Via this data transfer, each device can receive and transfer 8 IDNs
(SERCOS-II identifiers) or 16 words through the fast channel.
The communication speed selection between the regenerative power
supply and the drive governed by the SERCOS-II ring is made using
hardware via the “BOOT” button on top of the X6 connector. See figure F.
H8/41.
Parameter QP11
The parameter associated with the selection of the SERCOS-II ring
communication speed is QP11. See table T. S13/18 of chapter 13 in the
drive manual · man_dds_soft.pdf · for more information on parameter
QP11 and the various transmission speeds
.
F. H8/39
Minimum bending radius.
A.
Fiber optic cables SF0 and SF0-FLEX.
B.
Fiber
optic cable SF0-V-FLEX.
F. H8/40
Handling fiber optic cables.
NOTE. Consequently, the RS-232 serial connection will no longer be
necessary to select the transmission speed.
F. H8/41
Location of the «BOOT» button.
To Next Page
Loading...