FaroArm® Quantum
August 2017
106
Chapter 4: Probes
When the FARO Laser Line Probe is within the operating range, you will see the
line in the P
REVIEW AREA of the dialog box.
• Disable the Range Finder Laser box by clearing the RANGE FINDER LASER
O
N/OFF check box. For more information, see “Range Finder” on page 94.
• Disable the RANGE FINDER dialog box by clearing the RANGE FINDER
W
INDOW ON/OFF check box. For more information, see “Range Finder
Dialog Box” on page 96.
• Select the SHOW VISIBLE LIGHT check box to add all visible light to the
Preview window.
NOTE: Adding all visible light to the preview window will decrease the
number of frames per second sent to the computer and should only be used
when diagnosing problems with the FARO Laser Line Probe.
• Select the HIGH ACCURACY MODE check box to operate the FARO Laser
Line Probe in the High Accuracy mode. High Accuracy mode improves the
resolution of the FARO Laser Line Probe. However, it reduces your field of
view by one half and shortens your effective maximum scan line width to
Figure 4-20 FARO Laser Line Probe Control dialog box
08m80e00_FaroArm_Quantum.book Page 106 Tuesday, August 22, 2017 11:03 AM
To Next Page
Loading...
Need help?
General