Faro FaroArm Quantum - Using FARO I-Probes; Edit Probe

FaroArm® Quantum
August 2017
57
Chapter 3: Operation
Using FARO i-Probes
The standard 3 mm and 6 mm probes are FARO i-Probes. The exact diameter is
electronically recorded on the i-Probe. You do not need to edit any parameters of
the standard Quantum i-Probes.
NOTE: This generation of FARO i-Probe will not attach to the FaroArm
Edge, Platinum, or Fusion. Installing the i-Probe to anything other than the
FaroArm Quantum damages the i-Probe. Previous generations of the
FARO
i-Probe will not attach to the Quantum.
Edit Probe
Select any probe and click Edit to modify the details of the current probe.
Figure 3-32 Editing a Probe
08m80e00_FaroArm_Quantum.book Page 57 Tuesday, August 22, 2017 11:03 AM