FaroArm® Quantum
August 2017
55
Chapter 3: Operation
Probes
The Probes group controls your Quantum’s probe selection and settings.
Probe Management
Click Probe Management to change and edit a probe. In the PROBE
M
ANAGEMENT dialog box you can:
• Select the current probe and view the COMPENSATION STATUS.
• Create, Edit or Delete, or Duplicate a probe.
• Compensate the current probe.
• View the compensation log for the current probe.
• Start the Single Point Articulation Test (SPAT).
• Run an Arm Compensation or reset to the FARO Factory Arm
Compensation.
Figure 3-29 Probes dialog box
08m80e00_FaroArm_Quantum.book Page 55 Tuesday, August 22, 2017 11:03 AM
To Next Page
Loading...
