Faro FaroArm Quantum User Manual

FaroArm® Quantum
August 2017
153
Chapter 8: Configuring the Quantum in CAM2 Measure
Chapter 8: Configuring the Quantum in
CAM2
Measure
This chapter describes the operation of your Quantum with CAM2 Measure v10,
or later. Most of these commands start items from the FaroArm driver and are
available in other software packages. For more information in starting these
commands in other software packages, see the FaroArm section in your software
manual.
The DEVICE CONTROL panel contains all the commands for configuring the
Quantum. In Measure choose Device Control Panel on the Devices tab to show
the panel. You can also press the P hot key on the keyboard.
Device Control Panel ....................................................................................153
Add a Device ....................................................................................................................................154
Probe Management ...........................................................................................................................154
Hole Compensation ...........................................................................................................................155
Sphere Compensation .......................................................................................................................155
Hardware Configuration ...................................................................................................................155
Diagnostics ........................................................................................................................................156
Temperature ......................................................................................................................................157
Measurement Mode Setting ..............................................................................................................157
Measuring with the Quantum .......................................................................158
Adding Readings ...............................................................................................................................159
Device Control Panel
The DEVICE CONTROL panel contains a list of all active devices with the
properties of each associated device.
Choose the Quantum from the list to see the probe details.
•Click the >> button to hide the list of devices.
Figure 8-1 Device Control Panel
08m80e00_FaroArm_Quantum.book Page 153 Tuesday, August 22, 2017 11:03 AM

Faro FaroArm Quantum Specifications

General

Brand	Faro
Model	FaroArm Quantum
Category	Robotics
Language	English