FaroArm® Quantum
August 2017
159
Chapter 8: Configuring the Quantum in CAM2 Measure
Adding Readings
Use commands to control the Quantum instead of hardware buttons. Buttons (and
their associated hot keys) on the M
EASUREMENT panel are used for recording a
reading (G key), recording an end click (H key), and removing the last reading
(Backspace key).
You can also click the icons in the MEASUREMENT panel.
Record Measurement
Record End Click
Remove Last Reading
For more information, see the Measurement Panel section of the Measure
chapter in the CAM2
Measure manual.
Figure 8-7 Measurement Panel
08m80e00_FaroArm_Quantum.book Page 159 Tuesday, August 22, 2017 11:03 AM
To Next Page
Loading...
