FaroArm® Quantum
August 2017
28
Chapter 2: Setting up the Quantum
Removing the Battery Pack
1. On the rear of the base, open the door to access the battery pack slot.
2. Grab the cloth strip and pull out the battery pack.
3. Close the door and ensure the latch snaps.
CAUTION: Store the battery properly when not in use.
Charging the Battery Pack
Install the battery pack and connect the Quantum to a power outlet and the
battery pack will begin to charge. The battery pack will charge if the On/Off
button is set to the OFF position. Charging automatically stops when the battery
pack is completely charged.
• The Battery Power Indicator show the battery pack power level.
• The DIAGNOSTICS dialog box displays the current battery pack power level.
See “Diagnostics” on page 80.
WARNING: Only use the rechargeable battery pack supplied with your
Quantum. For information on ordering additional or replacement battery
packs, contact FARO’s Customer Service by
Phone, Fax or E-Mail. See
“Technical Support” on page 161.
You can also charge a battery pack using the Quantum Battery Charging Base.
For more information about the charging base, see the FaroArm Accessories
Manual.
Figure 2-19 Removing the battery pack
08m80e00_FaroArm_Quantum.book Page 28 Tuesday, August 22, 2017 11:03 AM
To Next Page
Loading...
Need help?
General