FaroArm® Quantum
August 2017
128
Chapter 6: Maintenance and Troubleshooting
Two.
• Can both USB and Bluetooth wireless Quantums be connected
simultaneously?
Yes.
• Can a single Quantum connect using both Bluetooth wireless and a USB
cable at the same time?
No. If both are properly connected, the Bluetooth wireless will be the
only active connection for that Quantum.
• Can I use a FARO Laser Line Probe with the FARO Wireless connection?
Yes.
• Can I add a Bluetooth wireless connection while the FaroArm driver is
already running?
No, the FaroArm driver must be unloaded before changing any FARO
Wireless settings.
• Why does it take longer for my measuring software to open when I use the
FARO Wireless connection?
The FaroArm driver requires more time to initialize when using a FARO
Wireless connection and this translates into slightly increased load times
for the measuring software.
• Why does it take longer for the PROBES dialog box to go away when I am
using a FARO Wireless connection.
Probe data saves in the Quantum and requires more time for this
information to transfer when using the FARO Wireless connection.
• What happens if I go out of range and lose my connection? What happens if
I turn off the Quantum while it is connected using the FARO Wireless
connection?
Once the FaroArm driver detects that the Quantum is no longer
connected, after about 10 seconds, a message appears asking if you want
to restore the FARO Wireless connection. If you click No, the
connection stops. If you click Yes, attempts are made to restore the
connection.
• Why do I continue to see the message asking if I want to continue to use the
FARO Wireless connection?
Either the Quantum has lost power, or it is out of the 30 feet or 10
meters wireless range. After correcting the problem, click Yes to restore
the connection.
08m80e00_FaroArm_Quantum.book Page 128 Tuesday, August 22, 2017 11:03 AM
To Next Page
Loading...
Need help?
General