Never operate the equipment with wet hands.
Failure to observe this instruction may cause electric shock.
Keep fingers away from the Controller (MFC) Unit radiating fin and tool motors while the
equipment is turned ON or for a while after the equipment is turned OFF. These parts may
become very hot. Failure to observe this instruction may cause burns.
Use the equipment under the following conditions.
◆ Ambient temperature: 0°C～+45°C (Avoid freezing)
◆ Ambient humidity: 85% RH or lower (Avoid moisture)
◆ Atmosphere: Indoors (Avoid direct sunlight)
No corrosive gases or flammable gases
No oil mist, dust, water, salt, iron powder
◆ Avoid direct vibration or shocks
Failure to observe this instruction may cause earth leakage and malfunction.
Confirm and adjust all parameters before operation in order to prevent unexpected movement
of the equipment.
Failure to observe this instruction may cause injury, false operation and malfunction.
Never conduct extreme adjustments or setting changes that may cause instability of operation.
Failure to observe this instruction may cause injury, false operation and malfunction.
The equipment may restart suddenly when the equipment is reset with the start signal ON.
Always ensure that the start signal is OFF before resetting the equipment.
Failure to observe this instruction may cause injury.
Do not turn ON and OFF the equipment repeatedly.
Failure to observe this instruction may cause malfunction.
Do not use the equipment at torque higher than the maximum torque.
Failure to observe this instruction may shorten equipment life or cause malfunction
due to the high temperature caused by overload.
In case any abnormality occurs, remove the cause and ensure safety before resetting
and restarting the equipment.
Failure to observe this instruction may cause injury.
Discharge any static electricity in your body before touching the operation switches of the
touch panel and front panel by first touching a grounded conductive object.
Failure to observe this instruction may cause malfunction.
If cleaning the Controller (MFC) Unit or tool use a cloth moistened with warm water or
alchohol. Do not moisten the MFC Unit or tool directly.
Failure to observe this instruction may cause injury.
To Next Page
Loading...
