Transport the equipment properly according to its weight.
Failure to observe this instruction may cause injury and malfunction.
The conditions when transporting the equipment by ship is as below.
◆ Ambient temperature: -5°C～+55°C (Avoid freezing)
◆ Ambient humidity: 50% RH or lower (Avoid moisture)
◆ Package: Tight seal
◆ Rust prevention measure: Apply grease or oil on tools.
Failure to observe this instruction may cause earth leakage and malfunction.
Do not hold cables and output spindles when transporting the tools.
Failure to observe this instruction may cause injury and malfunction.
Do not hold the indictor on the front panel when transporting the Controller (MFC) Unit.
The indicator may come off and drop from the front panel.
Failure to observe this instruction may cause injury and malfunction.
The equipment shall be stored under the following conditions.
◆ Ambient temperature: -5°C～+55°C (Avoid freezing)
◆ Ambient humidity: 85% RH or lower (Avoid moisture)
◆ Atmosphere: Indoors (Avoid direct sunlight)
No corrosive gases or flammable gases
No oil mist, dust, water, salt, iron powder
◆ Avoid direct vibration or shocks
Failure to observe this instruction may cause earth leakage and malfunction.
When discarding, please dispose of as industrial waste.
To Next Page
Loading...
