Certify Fiber Cabling
Autotest in Far End Source Mode
177
1-7 Make the connections to set the reference as shown on the
screen, then tap NEXT to see the completed connections.
Figure 67 also shows the completed connections.
Note
The SET REFERENCE screen shows reference
connections for the selected reference method.
Figure 67 shows connections for the 1 Jumper
reference.
Note
When you set the reference, keep the fiber as
straight as possible.
1-8 Turn on the optical source. On the CertiFiber Pro remote
module, hold down the button adjacent to the VFL port for 3
seconds to turn on the multimode source. See 68.
On CFP-QUAD modules, to turn on the single-mode source,
press the button again.
Note
The CertiFiber Pro module in the remote always
operates in auto wavelength mode. The output
port transmits both wavelengths (850 nm and
1300 nm or 1310 nm and 1550 nm). The signal
includes identifiers that tell the main tester when
to measure power at each wavelength.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
