Sync Projects with LinkWare
™
Live
Use LinkWare Live Through a Wi-Fi Network
347
5 On the LWL SIGN IN screen, if necessary, enter the ID and
password for your LinkWare Live account, then tap SIGN IN.
6 If you use other people’s LinkWare Live accounts, the
ORGANIZATION screen shows. Tap the organization you want
to use.
7 On the SYNC PROJECTS screen (Figure 129 on page 349), select
the projects you want to sync, then tap SYNC.
Use LinkWare Live Through a Wi-Fi Network
Note
The testers in some custom kits do not support
Wi-Fi (for example, in some kits purchased for
government applications). These testers do not
show any Wi-Fi settings.
Versiv 2 testers have an internal Wi-Fi radio. These testers do not
need an external adapter to connect to Wi-Fi networks.
To connect a Versiv tester to a Wi-Fi network, you must have an
optional USB Wi-Fi adapter. Fluke Networks recommends these
adapters:
• TP-LINK TL-WN725N, Versions 1 and 2 (recommended)
• NETGEAR WNA1000M
Other adapters may be suitable. For the latest list of qualified
adapters, see this topic in the Fluke Networks Knowledge Base:
www.bit.ly/1ACJeFO
To use a Wi-Fi network
1 For a Versiv that uses an external Wi-Fi adapter, connect the
Wi-Fi adapter to the tester’s type A USB port.
2 On the home screen, make sure the Operator name is correct.
The tester uses the email address associated with the operator
name as the ID when you sign in to LinkWare Live.
(continued)
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
