Versiv Series Cabling Certification Product Family
Users Manual
84
About Splitters
If you get these results, there might be a splitter on the cable:
• The tester cannot find the remote.
• The tester looses communication with the remote. The test
might continue, then loose communication again as the
splitter interferes with the communication signal.
• The length test shows End not found.
• The resistance test shows an open.
• The HDTDR plot shows a reflection that has an unusual shape.
Because splitters can cause unreliable test results, you should not
do tests through them.
Tests Without a Remote
You can do the length, resistance, and HDTDR tests without a
remote tester. Table 5 describes the effects of a remote on tests.
1 Attach a coaxial adapter to the main tester.
2 Make sure that the home screen shows the correct settings for
the job.
To make sure that other settings are correct, tap the test setup
panel, make sure the correct test is selected on the CHANGE TEST
screen, then tap EDIT to see more settings. Table 4 on page 78
describes the settings.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
