Fluke Versiv Series - Set up a Project; The PROJECT Screen

Versiv Series Cabling Certification Product Family
Users Manual
336
Set Up a Project
Refer to the PROJECT screen in Figure 127 on page 337.
1 On the home screen, tap the PROJECT panel, tap CHANGE
PROJECT, then tap NEW PROJECT.
2 On the NEW PROJECT screen, enter a name for the project,
then tap DONE.
3 On the PROJECT screen, tap the Operator panel to enter an
operator name for the project.
4 On the PROJECT screen, tap the NEW TEST button to enter
the tests and test settings necessary for the project.
5 On the PROJECT screen, tap the NEW ID SET button to make
one or more sets of cable IDs for the project. See the CABLE ID
SETUP screen in Figure 128 on page 341.
6 On the PROJECT screen, tap DONE.
The PROJECT Screen
To start a new project, tap the PROJECT panel on the screen.
Figure 127 shows the PROJECT screen and describes the items you
enter to make a project.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com