Versiv Series Cabling Certification Product Family
Users Manual
290
Do the SmartLoop test
1 Make the connections shown in Figure 111.
2 On the home screen, make sure the IDs for the fibers are
correct. The tester uses the Fiber A ID for the fiber connected
to the launch cord.
3 Tap TEST or press .
Note
If the tester shows a message about the
connection quality of the OTDR port, but the
OTDR connection on the tester is good, inspect
the ends of the loopback cord. See “Port
Connection Quality for SmartLoop Tests” on page
262.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
