Versiv Series Cabling Certification Product Family
Users Manual
72
Continuous Tests
To do the wire map, length, or resistance test continuously, go to
the home screen, tap TOOLS > Single Tests, then tap a test.
The wire map test compares the results to the outlet
configuration specified by the selected test limit and shows if
the connections agree or if they do not.
The length and resistance tests do not compare the results to a
test limit.
To save the result, tap SCAN OFF > SAVE. The saved test has an
for the overall result.
Long-Range Communication Mode (DSX-5000)
DSX-5000 modules have a long-range communication mode that lets
you do tests on very long cables, such as spools of cable and long
links used for voice communications. The DSX-5000 automatically
uses this mode when the cable is too long for normal
communications between the main and remote testers. For example,
a Cat 6 cable longer than approximately 200 m will cause the testers
to use long-range communication mode.
When the testers use long-range communication mode, the arrows
on the connection icon are orange:
Note
Tests take more time to complete in long-range
communication mode. For example, an Autotest
can take 90 seconds to two minutes to complete.
A very long cable will fail the Autotest, but you can measure cable
length and compare other results to results from a known- good
cable of the same length to see if the cable is good.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
