Use the OTDR
How to Remove and Install the Connector Adapters
193
Headset jack.
: Starts a test. To start a test, you can also tap TEST on the
display.
: Power button. Versiv 2: The LED in the power button shows
the status of the battery charging process. See Table 2 on
page 15.
: Press to go to the home screen.
Connector for the AC adapter. Versiv: The LED is red when the
battery charges, and green when the battery is fully charged.
The LED is yellow if the battery will not charge. See “Charge the
Battery” on page 14.
RJ45 connector: Lets you connect to a network for access to Fluke
Networks cloud services.
Decal with laser
safety information:
How to Remove and Install the Connector
Adapters
You can change the connector adapters on the OTDR ports of the
modules to connect to SC, ST, LC, and FC fiber connectors. You
can remove the adapter also to clean the fiber endface in the
port. See Figure 72.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
