Versiv Series Cabling Certification Product Family
Users Manual
238
The purple fiber is the loopback cord.
The fiber between the launch cord and the loopback cord is the
fiber on one side of the link.
Fiber A is the side of the link connected to the OTDR at End 1.
To switch between results for fibers A and B, tap on the
EventMap screen.
Note
When you save SmartLoop results, the tester saves
the results in two records, one for each fiber in
the link.
Bi-directional SmartLoop Tests
OTDR tests from both ends of a fiber can give different results
because some properties of fiber and fiber components can cause
differences in the loss measurements in each direction.
For example, the loss of an event is the difference between the
backscatter levels before and after the event. If a segment after a
connector or splice has a higher backscatter value than the
segment before, the tester shows different values of loss for the
connector or splice from the two directions.
For splices, which have very little loss, the difference in the
backscatter of the two fibers can cause an apparent gain in power
across the splice in one direction.
For this and other reasons, bi-directional averages of connector
and splice loss in both directions are more accurate than
measurements from one direction.
The bi-directional SmartLoop test gives you bi-directional OTDR
results for both fibers in a link. The tester also automatically
calculates averages of the two results and includes the averaged
values in the test record.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
