Versiv Series Cabling Certification Product Family
Users Manual
232
The SmartLoop Test
The SmartLoop test lets you connect the far ends of the two fibers
in a link and do one OTDR test to get separate results for each
fiber.
You use a launch cord to connect the fibers together at the far
end of the link. When you do the SmartLoop test, the tester uses
the launch compensation settings to remove the effects of the
loopback cord and its connectors.
The Auto and Manual settings for the SmartLoop test operate the
same as for the OTDR test. See Table 8 on page 199.
Figure 89 shows the equipment for the SmartLoop test.
Figure 89. Equipment for SmartLoop Tests
GPU169.EPS
Tester with OTDR module
installed
Three launch cords for launch,
tail, and loopback connections
(match the fiber to be tested)
Short patch cord (30 cm (12 in)
maximum) and adapter for bi-
directional tests (optional)
Two adapters
FiberInspector Pro video probe
with USB connector
Fiber cleaning supplies
AC adapter (optional)
A
B
F
G
E
D
C
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
