Sync Projects with LinkWare
™
Live
Change the Network Settings
353
Settings for the Wired Port
The tester can use DHCP (dynamic host configuration protocol) or
Static for the address method. Most networks use DHCP.
For Static, enter an IP address for the tester and the Subnet Mask,
Gateway address, and DNS1 and DNS2 addresses for the network.
If you are not sure what to enter, speak to the network
administrator.
Settings for Wi-Fi
Table 10 shows the Wi-Fi settings.
Note
The testers in some custom kits do not support
Wi-Fi (for example, in some kits purchased for
government applications). These testers do not
show any Wi-Fi settings.
Delete Wi-Fi Settings and Passwords
The tester saves the security settings and passwords for the Wi-Fi
connections you use.
To delete all Wi-Fi settings and passwords
On the home screen, tap TOOLS, then tap Network, tap the Wi-Fi
panel, then tap FORGET ALL.
Regulatory Information for the Wi-Fi Radio
To see the regulatory information
On the home screen, tap TOOLS, then tap Regulatory
Information.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
