Fluke Versiv Series - Make Sure Your Tester is Ready to Certify Cabling

Versiv Series Cabling Certification Product Family
Users Manual
42
 This icon shows when the talk function is on. To use the
talk function:
1 Connect the main and remote testers together through a
link that has one or more good wire pairs.
2 Connect headsets to the headset jacks on the testers.
3 Press the button on one of the headset microphones or
press  on the remote, then speak into the
microphone.
Make Sure Your Tester is Ready to Certify
Cabling
To make sure your tester meets its accuracy specifications, follow
these guidelines:
• Keep the tester’s software current. The latest software is
available on the website. See “Update the Software” on
page 359.
• Set the reference for the twisted pair adapters every 30 days.
See Set the Reference below.
• Make sure that you select the correct cable type for the job, and
that the NVP for the cable is correct. See Table 3 on page 46.
• Make sure you select the correct test limit for the job. See
Table 3 on page 46.
• Make sure the cords and connectors for all test equipment
and patch cords are in good condition.
• Make sure the battery is fully charged.
• Send the modules to a service center every 12 months for
factory calibration.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com