Use the OTDR
OTDR Results
215
The ID for the results. If Auto Save is off, Result not saved shows.
The end of the fiber.
The length of the fiber segment between two events.
A reflective event:
: A reflective event, which is usually a connector.
Measurements for the event are all within the test limits.
: One or more measurements for the event exceeds the limit.
This event could also be a Ghost Source.
: Launch and tail cords and their connectors show in gray. The
map shows these if Launch Compensation is on and the cords are
connected.
: The arrow icon shows when there are more events that do
not show on the screen. To see the events, tap the icon or scroll
the map.
When more than one button shows at the bottom of the screen,
the tester highlights one in yellow to recommend which one to
tap. See Buttons to Do Tests and Save Results on page 22.
The fiber type and test limit the tester used for the test, and the
ID the tester will use for the next results that you save.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
