Router Dynamic RIP
FortiGate Version 4.0 MR1 Administration Guide
01-410-89802-20090903 359
http://docs.fortinet.com/ • Feedback
Figure 187: Basic RIP settings
RIP Version Select the level of RIP compatibility needed at the FortiGate unit. You
can enable global RIP settings on all FortiGate interfaces connected
to RIP-enabled networks:
1 — send and receive RIP version 1 packets.
2 — send and receive RIP version 2 packets.
You can override the global settings for a specific FortiGate interface if
required. For more information, see “Configuring a RIP-enabled
interface” on page 361.
Advanced Options Select the Expand Arrow to view or hide advanced RIP options. For
more information, see “Selecting advanced RIP options” on page 360.
Networks The IP addresses and network masks of the major networks
(connected to the FortiGate unit) that run RIP. When you add a
network to the Networks list, the FortiGate interfaces that are part of
the network are advertised in RIP updates. You can enable RIP on all
FortiGate interfaces whose IP addresses match the RIP network
address space.
IP/Netmask Enter the IP address and netmask that defines the RIP-enabled
network.
Add Select to add the network information to the Networks list.
To Next Page
Loading...
