System Status Viewing application, policy, and DLP archive usage data
FortiGate Version 4.0 MR1 Administration Guide
01-410-89802-20090903 141
http://docs.fortinet.com/ • Feedback
DLP Archive Usage
DLP Archive Usage shows the volume of data that the FortiGate unit has sent to content
archiving (DLP Archive). You can categorize the information by DLP Rule, firewall policy,
protection profile, or protocol.
From the table display you can:
• View details about the data by pausing the mouse pointer over each bar in the chart.
• Select a bar on the graph to view more information about the data.
DLP Archive Usage data is collected by adding DLP sensors to protection profiles. Only
information about sessions matched by DLP sensors is added to the chart or table.
Sessions accepted by firewall policies that do not include protection profiles with DLP
sensors configured do not contribute to the data displayed.
Figure 55: DLP Archive Usage module
To configure the DLP Archive Usage module
1 Go to System > Status > Usage.
2 Select the Edit icon in the DLP Archive Usage module title bar.
3 Enter the following information and select OK.
Reset Reset all counts to zero.
Edit Configure module settings.
Refresh Update displayed information.
Close Close the module.
DLP Rule or
Policy or
Profile or
Protocol
The DLP Rule, firewall policy, protection profile or protocol, depending on the
Report By setting.
Bytes or
Messages
The volume of archived data in bytes or messages, depending on the
Sort Criteria setting.