Fortinet FortiGate Series

Router Monitor Viewing routing information
FortiGate Version 4.0 MR1 Administration Guide
01-410-89802-20090903 383
http://docs.fortinet.com/ • Feedback
Router Monitor
This section explains how to interpret the Routing Monitor list. The list displays the entries
in the FortiGate routing table.
If you enable virtual domains (VDOMs) on the FortiGate unit, router monitoring is available
separately for each virtual domain. For more information, see “Using virtual domains” on
page 159.
This section describes:
• Viewing routing information
• Searching the FortiGate routing table
Viewing routing information
By default, all routes are displayed in the Routing Monitor list. The default static route is
defined as 0.0.0.0/0, which matches the destination IP address of “any/all” packets.
To display the routes in the routing table, go to Router > Monitor.
Figure 204 shows the Routing Monitor list belonging to a FortiGate unit that has interfaces
named “port1”, “port4”, and “lan”. The names of the interfaces on your FortiGate unit may
be different.
Figure 204: Routing Monitor list