freightliner Sprinter Operator's Manual

Driving systems
128
Controls in detail
Activating the rear-view camera
E Make sure that the key is turned to
position 2 in the ignition lock.
E Engage reverse gear.
The rear-view camera is switched on.
Operating the monitor
Monitor buttons
1 : Down button
2 9 Up button
3 t Menu/Confirm button
4 u Monitor on/off switch
5 Loudspeaker cover
Switching on the monitor
You can switch on the monitor by:
O engaging reverse gear.
This activates the rear-view camera
which switches the monitor on.
O pressing the u button.
This activates the input for auxiliary
devices (AUX) on the monitor.
i If you switched the monitor off using the
u button, once you have engaged reverse
gear, you will need to press the u button.
Only then will the monitor come on.
Input for auxiliary equipment (AUX)
If you engage reverse gear while using aux-
iliary equipment, the monitor switches to
the rear-view camera.
When you disengage reverse gear, the
monitor continues to show the picture
from the rear-view camera for about
15 seconds before switching back to the
auxiliary input (AUX).
Switching off the monitor
If the monitor was switched on by engag-
ing reverse gear, it switches off automati-
cally 15 seconds after you disengage
reverse gear.
You can switch off the monitor by pressing
the u button. In this case, the following
message is shown for 7 seconds before
the monitor goes off.
Setting the volume
E Press the : or 9 button.
The volume of the built-in loudspeaker
is adjusted in increments.
iThe volume of the optional infrared head-
phones is adjusted on the headphones them-
selves.
E Press the t button to exit the
volume control.
i If you do not press a button for 7 seconds,
the monitor switches off the volume control.

freightliner Sprinter Specifications

General

Brand	freightliner
Model	Sprinter
Category	Automobile
Language	English