Frick QUANTUM - Page 110

S90-010 O FRICK
®
QUANTUM™ COMPRESSOR CONTROL PANEL
Page 110 OPERATION
Clear Remaining Delay ........................................... 26
CT Factor ................................................................ 25
DBS Motor Starter................................................... 26
Forced Unload Load Inhibit Delay........................... 26
High Motor Amps Alarm .......................................... 25
High Motor Amps Alarm Delay................................ 25
High Motor Amps Force Unload.............................. 25
High Motor Amps Shutdown.................................... 25
High Motor Amps Shutdown Delay.......................... 25
Horse Power ........................................................... 25
Low Motor Amps Shutdown ...................25, 93, 94, 96
Low Motor Amps Shutdown Delay .......................... 26
Motor Amps............................................................. 25
Power Fail Restart................................................... 26
Power Fail Restart - Time after power allowing
Restart................................................................. 26
Recycle delay.......................................................... 25
Service Factor......................................................... 25
Volts ….................................................................... 25
Motor Indication Box......................................................... 8
Full Load Amps ......................................................... 8
Kilowatts.................................................................... 8
Kilowatts - est............................................................ 8
Motor Amps............................................................... 8
Run Time Hours........................................................ 8
O
Off ..………..................................................................... 19
Oil ..……….. ................................................9, 99, 100, 101
Oil Level Shutdown ........................................................ 97
Oil Log Shutdown........................................................... 97
Oil Lubrication Devices, Status Box ................................. 8
Oil Pressure Sensor Fault .............................................. 97
Oil Pump .…................................................................... 97
#1 Aux. Alarm.......................................................... 97
#1 Aux. Failure Shutdown ....................................... 97
#2 Aux. Alarm.......................................................... 97
#2 Aux. Failure Shutdown ....................................... 97
Aux Failure.............................................................. 97
Oil Pump Mode............................................................... 12
Auto .… ................................................................... 12
Manual Off............................................................... 12
Manual On............................................................... 12
Oil Lead Pump 1...................................................... 12
Oil Lead Pump 2...................................................... 12
Oil Safety Logic ...............................................99, 100, 101
Oil Setpoints..............................................................17, 32
High Oil Temperature Alarm.................................... 32
High Oil Temperature Alarm Delay.......................... 32
High Oil Temperature Shutdown ............................. 32
High Oil Temperature Shutdown Delay................... 32
Low Oil Pressure Alarm........................................... 32
Low Oil Pressure Alarm and Shutdown................... 33
Low Oil Pressure Alarm Delay ................................ 33
Low Oil Pressure Shutdown.................................... 32
Low Oil Pressure Shutdown Delay.......................... 33
Low Oil Separator Temperature ............................. 32
Low Oil Separator Temperature Alarm.................... 32
Low Oil Separator Temperature Alarm Delay.......... 32
Low Oil Separator Temperature Shutdown ............. 32
Low Oil Separator Temperature Shutdown Delay ... 32
Low Oil Temperature Alarm .................................... 32
Low Oil Temperature Alarm Delay .......................... 32
Low Oil Temperature Shutdown.............................. 32
Low Oil Temperature Shutdown Delay.................... 32
Main Oil Injection Delay........................................... 33
Main Oil Injection On at Discharge Temp.................33
Oil Heater Off Above................................................32
Liquid Injection Oil Temperature Delay ....................33
Liquid Injection Oil Temperature On at.....................33
Oil Temperature Sensor Fault.........................................97
OK ..………. ................................................................6, 13
On ..………................................................................13, 19
On when above...............................................................43
Operating Status ................7, 13-16, 75, 82, 85, 87, 91, 92
Options Setup ...........................................................17, 40
Other Compressor Manuf................................................91
Overview Of Operator Interface ........................................4
P
Page Down .......................................................................6
Page Up ..…......................................................................6
Panel Heater ...................................................................13
Panel Setup …….……13, 14, 18, 66, 72, 75-79, 83, 91, 92
Permissive Start Always .................................................83
Permissive Start Disable ...........................................….83
Permissive Start Starting ................................................83
PID ……… .............................................................. 44-46
Differential Gain .......................................................46
Integral Gain.............................................................46
Proportional Gain .....................................................46
Proportional Only Control.........................................46
Setup ......................................................................44
Action................................................................45
Action Forward..................................................45
Action Reverse..................................................45
Actual................................................................45
Change Setpoints Dead Band...........................44
Change Setpoints Derivative Gain....................45
Change Setpoints High Limit.............................45
Change Setpoints Integral Gain........................45
Change Setpoints Low Limit .............................45
Change Setpoints Off Value..............................45
Change Setpoints Proportional Gain.................45
Control Always Active .......................................45
Control Disabled ...............................................45
Control 1.03 needed .........................................45
Control When Running......................................45
OFF Value 0% ..................................................45
OFF Value 100% ..............................................45
OFF Value Current Value..................................46
OFF Value High Limit........................................45
OFF Value Low Limit ........................................45
Output...............................................................45
Position ..….......................................................................9
Power Assist Disable ......................................................83
Power Assist Enable .....................................................83
Power Down Display .......................................................15
Power Fail Restart...........................................................80
Power Failure Restart Disable ........................................80
Power Failure Restart Enable .......................................80
Power Up Time................................................................13
Pressure Units...........................................................76, 77
Process Mode ...................................................................8
Process Temperature...........................8-10, 18, 19, 20, 24
Pumpdown . ....................................................7, 14, 17, 43
Always .....................................................................43
Delay .........................................................................7
Off when below ........................................................43
On when above........................................................43
Slide Valve Position .................................................43
Pumpdown/DX ...................................................14, 17, 81